Electronics Forum > Test Equipment

heathkit sb 614

<< < (2/3) > >>

kinkydoints:
Ok Got my replacement caps in... these are not the HV kit these are to replace the ones that looked original and were not in the HV kit.. Now for the caps that came with the HV circuit kit . there are three 1600 v .1mfd caps in the kit and look similar to the ones that are in the unit now, as im looking at this unit these have been replaced before...but look at the three cap set, the center is in opposite of the two that are on each side. OK question are these caps polarized ? there are no markings to pos or neg , both leads are the same length . as I look at the new ones there is a folded over lead ,all of these caps are printed on and are in the same orientation ,as far as the print on the cap and the folded end. pos or neg that is the question?
would a reversed cap cause issues down the line on other components?  thanks 

kinkydoints:
sorry about the GIANT pics ...

kinkydoints:
update on this sb614 have replaced caps in the hv circuit and tested on the bench , I have a link to a vid here.
https://vid.me/3EUg    seems to be fine ! thanks guys

k7rmj:
Congarats Kinky. Glad to hear you got it sorted out.

The Radio Shop:
Good job on getting her up and running again!

Navigation

[0] Message Index

[#] Next page

[*] Previous page