The Electronics Universe
Electronics Forum => Microcontrollers => Topic started by: The Radio Shop on June 17, 2016, 03:33:37 PM
-
Here is an error I get in avrdude
-
Top part in red of picture was a dry run without target connected.
Below was all connected so I have a driver issue.
-
So I connected the 328 onto a breadboard to program it directly. This way I should eliminate user errors.
It appears my firmware in my programmer needs an update.
-
First picture is my two USBasp devices.
Bottom pic is all my programming stuff including a PicKit 2 and a clone
-
So I decided to try this on my old tester. Now it has a different chip in it. So I knew there would be an error.
As you can see by the pic below the unit is communicating.
I have read a lot into the problem above and I am not sure if this is a firmware problem.
-
here is my old tester I need to repair
-
Wasn't your old tester using a 168 and not a 328?
-
Yep, so this was an upgrade.