The Electronics Universe

Electronics Forum => Electronic connection => Topic started by: kinkydoints on February 20, 2020, 03:10:23 PM

Title: yaesu ft7250 error message on transmit
Post by: kinkydoints on February 20, 2020, 03:10:23 PM

im looking for any info on a issue I have with my 7250. In November I left my truck at the airport long term parking with the radio ON, I have it hard wired to the battery with a 8 gauge set of wires to a power outlet setup after a heavy duty switch....bad move. 10 days later on return, after getting a jump start, my radio would not transmit . got "error" message on keying up mike. after a reset to factory settings via the book instructions.  not sure best fix? am I stuck with a return to factory to get serviced?

Title: Re: yaesu ft7250 error message on transmit
Post by: The Radio Shop on February 20, 2020, 07:11:40 PM

Not good. The microprocessor in those things are so touchy.  Going low volt did not corrupt the radio. it was the surge from the jump start. But you probably knew that.

Being that I have not serviced many of these I also know way to restore the cpu other than factory return.

Title: Re: yaesu ft7250 error message on transmit
Post by: kinkydoints on February 21, 2020, 11:59:01 AM

thanks Buddy , I kinda knew the options were limited. OK . now to set up that repair request.