1
Oscilosopes / Re: Yo100 help please
« on: April 06, 2017, 03:39:18 PM »
The main transformer and small transformer giving 6.3volts for crt and valve heaters
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
3
Oscilosopes / Re: Yo100 help please
« on: April 06, 2017, 03:35:09 PM »
View of board with valves and crt
4
Oscilosopes / Re: Yo100 help please
« on: April 06, 2017, 03:33:30 PM »
Today with not much experience i wired up transformers and switched it on all valves light up and crt and to my surprise have a trace on screen the vertical and horizontal work and focus but some don't function as I still have two sets of wires the two brown and the two orange and white that I am not sure of voltages regards graham
5
Oscilosopes / Re: Yo100 help please
« on: April 05, 2017, 04:11:31 PM »
These are the six I replaced
6
Oscilosopes / Re: Yo100 help please
« on: April 05, 2017, 04:08:15 PM »
Three of the 5 capacitors were dead so changed all five these were on the rectifier board they look like they got really hot would this have caused the transformer to go u/s in the first place regards graham
7
Oscilosopes / Re: Yo100 help please
« on: April 03, 2017, 02:09:16 PM »
The two orange and white cables go to rectifier board from transformer
8
Oscilosopes / Re: Yo100 help please
« on: April 01, 2017, 04:10:40 PM »
Also found two brown wires under crt I think these also went on transformer so the two sets I am not sure of voltages they need is the two orange and white and the two brown regards graham
9
Oscilosopes / Re: Yo100 help please
« on: March 31, 2017, 04:09:42 AM »
Many thanks regards graham
10
Oscilosopes / Re: Yo100 help please
« on: March 29, 2017, 11:43:36 AM »
This is what it's like the other side of the board mains lead cut and block added also one side of switch cut
11
Oscilosopes / Re: Yo100 help please
« on: March 29, 2017, 05:52:26 AM »
Many thanks for your help can you tell me the two orange and white wires that originally went on old transformer what voltage are these I know the three blue are 6.3 volt I think the orange and white are 30volt I might be wrong and you were right two cappacitors are gone 600v ones I would say someone could not get a transformer with right voltages so have done this so they need a seperate supply as they fitted two power sockets at back off unit to supply 6.3volt for crt and what ever the orange and white feed is regards graham
12
Oscilosopes / Yo100 help please
« on: March 28, 2017, 12:10:18 PM »
Hi hope somebody can help I bought a yaesu monitor scope yl100 mains lead was missing so opened up today and looks like transformer has been replaced and unfinished as I now have two connector blocks the largest has wires from crt and the small one has two orange and white cables in I think this was done as transformer does not supply the these voltages I may be wrong were do I start any advice please regards graham
Pages: [1]