Electronics Forum > Microcontrollers
transistor tester error and programming
The Radio Shop:
Here is an error I get in avrdude
The Radio Shop:
Top part in red of picture was a dry run without target connected.
Below was all connected so I have a driver issue.
The Radio Shop:
So I connected the 328 onto a breadboard to program it directly. This way I should eliminate user errors.
It appears my firmware in my programmer needs an update.
The Radio Shop:
First picture is my two USBasp devices.
Bottom pic is all my programming stuff including a PicKit 2 and a clone
The Radio Shop:
So I decided to try this on my old tester. Now it has a different chip in it. So I knew there would be an error.
As you can see by the pic below the unit is communicating.
I have read a lot into the problem above and I am not sure if this is a firmware problem.
Navigation
[0] Message Index
[#] Next page
Go to full version