Author Topic: The Pine Board Project (Metal Chassis Version)  (Read 186 times)

0 Members and 1 Guest are viewing this topic.

Offline The Radio Shop

  • Administrator
  • Hero Member
  • *****
  • Posts: 6103
  • Karma: +321/-2
    • View Profile
The Pine Board Project (Metal Chassis Version)
« on: July 07, 2020, 04:47:32 PM »
In this thread we will be documenting "The Pine Board Project".
Ours will be in a metal chassis.

See link below to Bob Heil's website on this for more videos and documentation.
https://heilhamradio.com/amateur-radio-post/the-pine-board-project/

All credit for this goes to Bob Heil and his team on building this project.
Buddy kc4umo


Offline The Radio Shop

  • Administrator
  • Hero Member
  • *****
  • Posts: 6103
  • Karma: +321/-2
    • View Profile
Re: The Pine Board Project (Metal Chassis Version)
« Reply #2 on: July 09, 2020, 08:01:27 AM »
Started the power supply.

First thing I did was build the tube rectified circuit on the breadboard. We ended up with about 190 volts on the B+.
Now we know the transformer is 250 volts but this is what happens when you use tube rectification.

EDIT TO ADD PICTURES


I then built up a solid state  circuit.  But this time we get 390 volts on the B+ and a tap for the preamp at 190 volts.
Remember this is unloaded. No load on the supply.

EDIT TO ADD PICTURES
Buddy kc4umo

Offline The Radio Shop

  • Administrator
  • Hero Member
  • *****
  • Posts: 6103
  • Karma: +321/-2
    • View Profile
Re: The Pine Board Project (Metal Chassis Version)
« Reply #3 on: July 09, 2020, 07:35:08 PM »
Power supply has started. I decided to go with solid state. This is because the extra voltage is needed for more power out of the transmitter.
Buddy kc4umo